View larger
JA-102KY JABLOTRON Mercury Alarm system control panel
Installation should be done by a trained technician with a valid certificate issued by an authorized JABLOTRON a.s. distributor.
The required settings and system parameters are programmed via MyCOMPANY. The setup is intuitive and very simple even for novice installers.
More info
The JA-102K control panel offers:
- up to 31 wireless or bus peripherals
- up to 32 users
- up to 4 sections
- up to 2 programmable PG outputs
The control panel has:
- 1 terminal block for bus connection
- 1 connector for built-in radio module (JA-111R)
- 1 connector for GSM/GPRS communicator (JA-194Y-LITE)
Technical specifications
| Instalation type | Fixed instalation |
|---|---|
| Control panel power supply / frequency / fuse | ~ 110-230 V/50-60 Hz, max. 0.28 A with F1.6 A/250 V fuse, protection class II |
| Power / current | max 23 VA / 0.1 A |
| Protection class | II. |
| Back-up battery | 12 V; 2.6 Ah max (lead gel) |
| Low backup battery voltage (fault indication) | ≤11 V |
| Maximum battery recharge time (80% capacity) | 72 h |
| Bus supply voltage / max ripple (red - black) | 12.0 ÷ 13.8 VDC / ±100 mV |
| Max. continuous consumption from control panel | 1000 mA |
| - with 12 h backup (2.6 Ah battery) | Without GSM communicator | LAN - off: 115 mA | LAN - on: 88 mA |
| With GSM communicator | LAN - off: 80 mA | LAN - on: 53 mA | |
| Max. number of sections | 4 |
| Max. number of peripherals | 31 peripherals + 31 drivers |
| Max. number of users | 32 |
| Max. number of PG outputs | 2 |
| Alarm connections |
|
| Alarm device classification | Security level 2 / environment class II |
| - In accordance with | EN50131-1, EN 50131-3, EN 50131-6, EN 50131-5-3 (using the radio module), EN 50131-10, EN 50136-1, EN 50136-2 |
| - Environment | Indoor general |
| - Operating temperature/humidity range | -10 °C to +40 °C/75% non-condensing |
| - Power supply | Type A - primary power supply with rechargeable backup battery |
| - Event memory capacity | of approx. 7 million recent events including source, date and time |
| - system response to loss of communication with periphery | Fault or Sabotage - depending on settings and profile
|
| - System reaction to incorrectly entered codes | after 10 incorrectly entered codes a sabotage alarm is declared and, depending on the selected profile, all control devices are blocked for 10 minutes. |
| - ATS classification | Supported ATS classes: SP2 - SP5, DP2 - DP4 SPT: Type Z Type of operation: Pass-through LAN on board: SP2 - SP5 (with IP protocol) JA-194Y LITE SP3 - SP5 (JABLO IP, ANSI SIA, DC-09) LAN + JA-194Y LITE DP2 - DP4 JABLO IP, ANSI SIA, DC-09) |
| - ATS alarm transmission protocols | JABLO IP, SIA IP, Contact ID, |
| - ATC security against substitution and information protection | Jablotron protocols: proprietary AES encryption with minimum 128-bit ANSI SIA key DC-09.2012 protocol with 128-bit AES encryption |
| LAN communicator | Ethernet interface CAT 5 (RJ-45) |
| Dimensions | 268 x 225 x 83 mm |
| Weight with/ without ACU | 1809 g/919 g |
| Basic parameters of the JA-111R module | 868.1 MHz, <25 mW, GFSK <80 kHz |
| Radio emission | ETSI EN 300 220-2 (JA-111R module) |
| EMC | EN 50130-4, EN 55032, ETSI EN 301 489-1, ETSI EN 301 489-3 |
| Electrical safety | EN IEC 62368-1 |
| Conditions of operation of the CTU radio module | ERC REC 70-03 |
| Certification body | TREZOR TEST (No. 3025) |